Toll Free 1800 572 9282 
mailus@wbcsmadeeasy.in
Circuit Breaker – Electrical Engineering Notes – For W.B.C.S. Examination.
An electrical circuit breaker is a switching device which can be operated manually and automatically for controlling and protecting an electrical power system.Continue Reading Circuit Breaker – Electrical Engineering Notes – For W.B.C.S. Examination.
As the modern power system deals with huge currents, special attention should be given during designing of a circuit breaker to ensure it is able to safely interrupt the arc produced during the closing of a circuit breaker. This was the basic definition of circuit breaker.
The modern power system deals with huge power network and huge numbers of associated electrical equipment. During a short circuit fault or any other type of electrical fault (such as electric cable faults), a high fault current will flow through this equipment as well as the power network itself. This high current may damage the equipment and networks permanently.
For saving these pieces of equipment and the power networks, the fault current should be cleared from the system as quickly as possible. Again after the fault is removed, the system must come to its normal working condition as soon as possible for supplying reliable quality power to the receiving ends. In addition to that for proper controlling of the power system, different switching operations are required to be performed.
So for timely disconnecting and reconnecting different parts of power system network for protection and control, there must be some special type of switching devices which can be operated safely under huge current carrying condition.
During the interruption of large current, there would be large arcing in between switching contacts, so care should be taken to quench these arcs in circuit breaker in a safe manner. The circuit breaker is the special device which does all the required switching operations during current carrying condition. This was the basic introduction to circuit breaker.
The circuit breaker mainly consists of fixed contacts and moving contacts. In normal “ON” condition of the circuit breaker, these two contacts are physically connected to each other due to applied mechanical pressure on the moving contacts. There is an arrangement stored potential energy in the operating mechanism of circuit breaker which is released if the switching signal is given to the breaker.
The potential energy can be stored in the circuit breaker by different ways like by deforming metal spring, by compressed air, or by hydraulic pressure. But whatever the source of potential energy, it must be released during operation. The release of potential energy makes the sliding of the moving contact in a speedy manner.
All circuit breaker have operating coils (tripping coils and close coil), whenever these coils are energized by switching pulse, and the plunger inside them displaced. This operating coil plunger is typically attached to the operating mechanism of circuit breaker, as a result the mechanically stored potential energy in the breaker mechanism is released in forms of kinetic energy, which makes the moving contact to move as these moving contacts mechanically attached through a gear lever arrangement with the operating mechanism.
After a cycle of operation of circuit breaker the total stored energy is released and hence the potential energy again stored in the operating mechanism of the circuit breaker using spring charging motor or air compressor or by any other means.
Till now we have discussed mechanical working principle of circuit breaker. But there are electrical characteristics of a circuit breaker which also should be considered in this discussion of the operation of the circuit breaker. Let’s have a discussion on electrical principle of circuit breaker.
Please subscribe here to get all future updates on this post/page/category/website
